Knowledge Hub Search – Search All Our Sites

Operating Department Smart Search


Sort :
Loading...
Go to Page :
Showing posts with label Safety Devices. Show all posts
Showing posts with label Safety Devices. Show all posts

Jan 5, 2021

DIESEL LOCO - Safety Devices

DIESEL LOCO - Safety Devices Safety devices are provided for the safety of the engine & loco. They are 1. Over Speed Trip Assembly (OSTA) - It is located on engine right side free end. It protects the engine from over speeding. On 8th notch the engine rpm is 1050. Due to any reason engine speed exceeds up to 1180 ± 20 rpm, OSTA will operate, fuel rack comes to zero and engine will shut down without any indication. Two handles are provided on OSTA, small is trip handle and big is reset handle. To reset OSTA, pull reset handle gently.  Note -
  • If OSTA trips during transition, reduce one notch.
  • If OSTA trips on higher notches, work on lower notches.
  • If OSTA trips repeatedly, check the wire connections of Techo. generator and inform the power controller.
  • Ensure that OSTA is reset before starting the engine and press the governor linkage.
2. Oil Pressure Switch (OPS) - In EH governor it is located in loco pilot cab on nose compartment wall, whereas in WW governor loco, it is inside the governor. It protect engine from low lube oil pressure. In EH governor loco OPS pick up at 1.6 kg/cm² and drop at 1.3 kg/cm². When oil pressure drops to 1.3 kg/cm², OPS operate and engine will shut down with following indication -
  1.  Low lube oil lamp will glow on both control stands.
  2. Alarm bell will ring.
  3. In WW governor shut down plunger will came out. In WW governor OPS pick up at 1.3 kg/cm² and drop on 1.1 kg/cm². Engine will not crank till shut down plunger reset properly.
3. Low Water Switch (LWS) - It is located in Expresser room below expansion tank no.1. It protects the engine from low water. Each expansion tank capacity 155 liters and its level is 14 inch. Whenever water level remain 1 inch LWS will operate, engine will shut down with following indication
  1. Alarm bell will ring.
  2. Hot engine lamp will glow on both control stands.
Note - If LWS defective, check the water level, if it is sufficient then short the wire 50D - 5OJ in EH governor and 16E - 16H in WW governor and inform the power controller.
  Disclaimer:The Information/News/Video provided in this Platform has been collected from different sources. We Believe that “Knowledge Is Power” and our aim is to create general awareness among people and make them powerful through easily accessible Information. NOTE: We do not take any responsibility of authenticity of Information/News/Videos.

Translate in your language